Crawler type shot blasting machine What needs to be checked daily?

Crawler type shot blasting machine is a widely used shot blasting machine, also known as crawler type shot blasting machine. It uses the high-speed rotating impeller to throw the shot to the indoor workpiece to achieve the purpose of cleaning. It is a new product of comprehensive technology research and design. New single disc shot blasting machine and hypothetical roller surrounded by rubber belt are used to make the workpiece roll evenly after cleaning, reduce collision, and have good cleaning effect. After working, it can discharge automatically. From small and medium-sized castings, forgings, stamping parts to non-ferrous metal castings, gears and springs for sand cleaning and rust removal, and then to scale removal and surface strengthening, you can almost see the shadow of the crawler type shot blasting machine. This machine is equipped with a dust remover, which meets the national environmental protection emission standards. With low noise, small floor area, stable performance, safety and reliability, it is an excellent and ideal cleaning equipment in China.

After use, the crawler shot blasting machine shall be inspected regularly to extend its service life. So, where is the inspection? The following is a look at the Xiaobian of Vivid environmental protection equipment manufacturers.

1. Indoor inspection

After shutdown for 5 hours, check the protective plate of the cleaning room, the steering wheel of the shot blasting machine Shot distributing wheel Wait for the equipment to see the degree of wear. According to the rules specified in the application, the degree of wear has reached the level of replacement and replacement. It should be noted that the guard board needs to be replaced regularly according to the use condition.

2. Outdoor inspection

Look at the periphery of the machine. First, we need to look at its transmission device to see if it is worn. Assuming there is wear, we can take a closer look at wear according to. The shot blasting machine manufacturer assumes that the demand reaches the critical point, and it needs to be replaced and repaired. When checking the track, check the wear degree of the track, and choose whether to follow according to the depth of the wear degree. If any, follow and replace the track. We are required to remove the drying part, make four hooks with steel bars, and hang the transmission shaft and track on the process hole on the upper part of the box for replacement.

3. Check the fan.

Fans are more important. With the extension of service time, the fan blades will attach a lot of dust. If it is not picked up in time, the weight of the fan will be deformed and the speed will be uneven after a long time. Therefore, according to the specified requirements, we need to work on the machine for 48 hours to tidy up sectors.

For the crawler type shot blasting machine, it is required to stop the machine in advance during the inspection, and the inspection can be conducted only after the machine is stopped.

The working principle of the crawler type shot blasting machine is relatively simple, but there are also many noteworthy points. After the specified number of workpieces are added into the cleaning bin, the door is closed, the machine starts, the workpieces are driven by the roller, and begin to turn over. At the same time, the shot shot thrown by the shot blasting machine at high speed forms a fan-shaped bundle, hitting the surface of the workpiece evenly, so as to achieve the purpose of cleaning. The shot and sand thrown out flows into the screw conveyor at the bottom from the small hole on the track, is fed into the elevator through the screw conveyor, and is lifted from the elevator to the separator for separation. The dusty gas is sucked into the dust remover by the fan and filtered, then becomes clean air and is discharged into the atmosphere. The dust falls into the dust collection box at the bottom of the dust collector through air blowback, and users can remove it regularly. The waste sand flows out of the waste pipe, and users can recycle it. The shot sand mixture is recycled to the room through the recovery pipe, and then recycled after separation by the separator. The layout of shot blasting machine is dynamically simulated by computer in three dimensions, and all layout angles and positions are determined by computer design. On the basis of taking care of all workpieces to be cleaned, try to reduce the empty throwing of projectiles, so as to improve the utilization rate of projectiles and reduce the wear of protective plates in the cleaning room.