The hook shot blasting machine is composed of shot blasting and rust removal room, bucket elevator, separation equipment, screw conveyor, shot blasting machine general program, shot automatic control system, hook travel track, hook system software, rotating equipment, subgrade, dust removal equipment, electrical control system, etc.

Shot blasting and rust removal chamber The shot blasting and rust removal chamber is composed of chamber body, guard board, etc. The ash removal port is set on the rear inner wall. The shot blasting chamber cover is a welded structure of thick steel plate and channel steel, which is the airtightness and wide practical operation room space for shot blasting of steel parts. One side of the inner wall of the shot blasting and rust removal chamber is equipped with a shot blasting master to ensure that the steel parts to be removed are shot blasted and rust removed in an all-round way. The area where the chamber body is immediately shot by the shot blasting machine is lined with an imported cold-rolled Mn13 guard plate with a thickness of 12mm, and the service life of a single shift production can exceed 10 years. 63Mn plate is used for safety protection in other areas. The guard boards are clamped with safety protection screw caps, which is conducive to removal and replacement when necessary. The lower part of the chamber body is arranged into a circular arc by thick steel plates, so that its projectiles are injected into the screw conveyor at the bottom. The thick steel plate is also paved with a guard board for safety protection.

The upper side of the screw conveyor is paved with a steel bushing, and the upper side of the bushing is paved with a wear-resistant rubber plate. During application, the wear-resistant rubber plate shall be laid on the left rear of the shot blasting machine to maintain the lower steel bushing and increase its service life. The basic model of the machine is equipped with manual feeding port method for manual service. The design concept of the machine is double door. The inner side of the door is paved with wear-resistant rubber guard board. The steel bending machine is clamped with hexagonal special nuts; There are foam plastic vulcanized rubber sealing strips around the door to seal the door reasonably; There is a ball slot below. When opening and closing the door, a small part of the ball is made to enter the room, so as to avoid the ball falling on the road, causing people to fall down and get injured. An oil pointer is set on and below the door hinge at the gate to facilitate the quarterly lubrication of the rolling bearing in the loose leaf at the gate.

Hook type shot blasting machine The bucket elevator is very important for the operation of the shot blasting machine. Steel ball recovery system of hook shot blasting machine. Hook shot blasting machine refers to hanging shot blasting machine. Steel rotation, shot blasting and rust removal, environmental protection.

Bucket elevator is composed of cycloidal pin reducer and motor shaft, upper, lower, left and right rollers, transport belt, silo, closed drum and tensioning equipment. The lower feed inlet of the bucket elevator is connected with the screw conveyor, and the upper feed inlet is connected with the shot separation equipment. Electric welding structure is selected for bucket elevator cover, which has beautiful appearance and good rigidity. The bucket elevator is equipped with a maintenance door at the top and bottom of the plug cover, which can be used to overhaul and replace the silo. Open the door cover on the lower cover, the lower transmission system can be overhauled, and the bullet blockage at the bottom can be removed. The machine selects the flat belt for rotation. During the working process, the silo fixed on the transport belt lifts the ball at the bottom of the bucket machine, and then the ball is lifted to the top of the bucket machine under the drive of the bucket machine motor. Through the method of filtering force, it enters the ball sand and is separated from the sand. There is a complete set of tensioning equipment under the bucket crane. When the drive belt is loose after a period of application, the drive belt can be tensioned according to the adjusting anchor bolts on both sides of the upper end of the bucket elevator. The adjustment range is 150mm, and attention shall be paid to make the adjustment amount on both sides the same.