Through shot blasting machine What should be paid attention to in safe operation of? The manufacturer of through shot blasting machine will give you a detailed introduction

The shot blasting machine is a kind of mechanical equipment, which can remove air scale, channel steel, stainless steel plate, seamless steel pipe and other raw materials, and conduct integrated treatment. In the application process, in order to ensure the safety of mechanical equipment, people must do the following:

1. It is forbidden to violate the operation process of the through shot blasting machine, otherwise it will cause unnecessary damage;

2. When the equipment is running, the actual operating staff and the loading and unloading staff should wear goggles and work clothes and hats;

3. Since the running speed of steel parts is not significant, it is forbidden to stand on the track during the whole fitness process, especially those standing in the direction of steel parts fitness. Actual operation and observation of pill cleaning;

4. During the operation of the equipment, it is forbidden to open the inspection door of the entrance and exit sealed warehouse;

5. The rubber seals inside the shot blasting machine are easy to ignite, and the operating temperature is prohibited to exceed 150 ℃. Fire prevention is required during maintenance;

6. The warning board must be hung on the electrical cabinet, and the main switch power must be disconnected when entering the equipment for maintenance;

7、 Shot blasting machine Do not open the machine cover during the whole process of fitness exercise;

8. Drive chain, V-belt and other protective covers can only be taken out during maintenance, and the equipment shall be firmly installed during operation;

9. During maintenance, it is forbidden to leave special tools at screw type, drive chain, motor end, etc.

How does the manufacturer of through shot blasting machine carry out actual operation and maintenance?

Through cleaning equipment, it is this kind of cleaning equipment for us, but it is very different from other cleaning equipment, so it needs to be demonstrated and mastered. But in summary, it is still this kind of cleaning equipment, different from shot blasting equipment, and its actual operation and maintenance are described in detail below.

1. Actual operation

(1) Before starting work, check whether the secret formula of cleaning solution is suitable and whether the height width ratio of liquid level in the water storage tank meets the standard.

(2) Set the heating temperature and heat the cleaning solution according to the electric heater.

(3) If the cleaning solution is heated to the set temperature, the cleaning can be started. Press the button to start working, and then the centrifugal pump, transportation and its cleaning start position.

(4) When the mechanical equipment starts to work, the actual operating staff can clean while transporting.

2. Maintenance

(1) The specific personnel shall carry out actual operation, application and maintenance of the equipment, master the characteristics of the equipment, master the safety operation procedures, and strictly implement them.

(2) If any abnormal phenomenon is found during the working process of mechanical equipment, it shall be shut down immediately and solved by professional technicians.

(3) The lubrication shall be carried out regularly to ensure that the rolling bearings can work normally.

(4) The drinking water and the necessary amount of detergent shall be regularly increased to fill the consumption and keep the liquid level at the necessary aspect ratio.

(5) The maintenance shall be carried out regularly, so as to solve problems in time.

(6) If the cleaning fluid cannot meet the cleaning regulations, it should be replaced.