shot blasting machine Installation and use method of

Crawler type shot blasting machine The working principle of is to put a certain number of workpieces into the warehouse, then close the gate, start the machine, and the workpieces are driven by the roller to turn over. At the same time, the thrown shells form a fan-shaped beam, evenly hit the surface of the workpiece, and stop finishing. The ball and sand flow into the screw conveyor from the small hole on the track, then into the elevator, and then stop separation in the separator.

Crawler type shot blasting machine shall be installed step by step before operation, and can only operate normally if it is installed correctly. According to the concrete of local soil equipment, after checking the straight and horizontal surfaces with a level gauge, the crawler type shot blasting machine can be installed and the bolts can be fastened around the feet. Crawler type shot blasting machine shall be gradually installed before normal operation.

The user can install the crawler type shot blasting machine according to the local soil equipment concrete, check the plane straightness and horizontal elevation with a level gauge, and tighten the foundation bolts. Therefore, the following steps should be followed to install the crawler type shot blasting machine: before leaving the factory, the crawler type shot blasting machine will assemble the cleaning room and the shot blasting machine into a whole, and the elevator and elevator should be bolted to the cleaning room.

When installing the crawler type shot blasting machine, pay attention to adjusting the drive pulley bearing seat to keep it horizontal and avoid belt deviation; Install manual shot blasting valve and shot blasting valve on the separator, and connect all pipelines according to the dedusting system diagram. Separate waste users can bring their own trash cans for treatment; When the separator device operates normally, there is no gap in the ejection flow curtain.

If full curtains cannot be formed, adjust the weight until full curtains are formed. The separation effect of particles and sand of the shot blasting machine is not good. The separation plate can be adjusted to regularly remove the large pieces of materials separated by the particle sieve to achieve good separation effect; The lifting belt is connected by the user's hole.

The above is the installation process of the crawler shot blasting machine, and I hope it will be helpful to you.